Dinosaur Electronics Ignitor Boards Fan Control FAN 50 PLUS PINS

Dinosaur Electronics Ignitor Boards Fan Control FAN 50 PLUS PINS. Heater Ignitor Boards Fan Control Boards. The FAN 50 Plus Pins is designed to replace the new Suburban Fan Control boards and the Atwood HydroFlame Fan Control boards.

$108.95
  • SKU: FAN50PLUSPIN*
Qty: - +
- OR -

Dinosaur Ignitor Boards Fan Control FAN 50 PLUS PINS

FAN 50 PLUS PINS Uses the new 6 pin Connector

The FAN 50 Plus Pins is designed to replace the new Suburban and Atwood / HydroFlame Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature.

The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.

The FAN 50 Plus Pins , after shutting the fan motor off, will wait for 1 hour and repeat the whole sequence again before permanent shut down.

For 12 VDC Furnaces ONLY!

Ignitor Board Dimensions
The UIB S & UIB S Post: 3.25 in. x 4.25 in.
The UIB L & UIB L Post: 3.43 in. x 5.10 in.
Fan 50 Plus Pins: 3.25 in. x4.25 in.

*Note: Fan control boards should not be used in DuoTherm 900 series furnaces that have the thermostat in the ground circuit. DuoTherm furnaces can be rewired to move the thermostat from the ground side of the circuit to the positive side of the circuit so that the Fan control features of the Fan control or FAN 50 Plus Pins board can be used.

Currently there are no reviews for this product. Share your opinion with others, be the first to write a review.

Add Your Review


Your Name:
Email Address:
Review:
Note: HTML is not translated! Your email address will not be shared with anyone.
Your Rating: 5

Your Name:
Your Email:
Friends Name:
Friends Email:
Subject:
Message: